JOB PERFORMANCE MEASURE
30-21-150-002-004 Calibrate Honeywell ElectroniK 17 Temperature
SECTION I - EVALUATOR GUIDE
Section I.B of this document is considered test material and as such can not be left
unattended nor given to the trainee.
BE ADVISED THAT SECTION I.B. "EVALUATION GUIDE" IS CONFIDENTIAL AND ITS
CONTENTS CANNOT BE DISCUSSED WITH OR SHOWN TO THE TRAINEE PRIOR TO THE
Verify that the prerequisites and training requirements have been fulfilled:
Review Section I.C. "Qualification Card" to verify that the "Prerequisites"
have been signed off by the Training Coordinator.
Review Section I.C. "Qualification Card" to verify that "Training" has been
signed off by the OJT Trainer.
Set-up the JPM as follows:
Loveland 450 A Temperature Calibrator (Category 1);
Type K Thermocouple Extension Wire; Chart Paper;
Approved Work Clearance Permit or
Management/Supervision Authorization to perform
N/A for this JPM.
Provide the trainee Section II-Trainee Guide.
Allow sufficient time for the Trainee to review the Trainee Instructions and Guide.