Click here to make tpub.com your Home Page

Page Title: Shop tests
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 



DOE-SPEC-3019-96
ATTENTION:
The following paragraph is optional depending on battery use.
********************
6.2.1
Pilot cell. Designate a pilot cell on the basis of the test results for each battery
system's permanent record. With the battery shipped wet, it shall be the cell with
the lowest voltage after the battery is charged.
ATTENTION:
Enter acceptable tolerances in subparagraphs a and b, below. A 40 mV deviation from nominal volts per cell
(Vpc) is the normal maximum tolerance for lead-calcium cells. Lead antimony cell tolerance is normally 20 mV.
Specific gravity tolerance is normally +/- 10 points.
********************
6.2.2
Production tests. Perform the following production tests at the factory:
Cell voltage measurement. The tolerance shall be [40 mV]
6.2.2.1
mV] from a nominal [2.25] [  ] V/cell.
[
Pressure-relief vent operation and reseal. Shall pass
6.2.2.2
manufacturer's standard test.
Cell-jar leakage test. The cell shall be pressurized with air and the
6.2.2.3
pressure shall remain constant.
Field tests. The Owner will perform a battery performance test in accordance with IEEE
450 on the fully-assembled batteries at the job site. The test will be based on the battery
manufacturer's ampere-hour rating of the battery. Seller may attend this test as noted in
Appendix B, paragraph 8.
ATTENTION:
Enter all shipping instructions. Batteries should be shipped wet and fully charged. It may be advantageous to
ask for special packing to facilitate handling the components when received, or grouping parts in a way that
facilitates installation. Special shipping instructions may also include a dedicated truck to expedite delivery.
********************
Cleanliness. At the time of shipment, the equipment shall be clean inside and outside.
Remove all rust, oil, grease (except corrosion-inhibiting compound on cell posts), chalk,
crayon, and paint marks, and other deleterious material from all surfaces of the equipment.
Touch up any cuts, nicks, or scratches to the coating system.
a. Prepare equipment for shipment to protect it from damage during shipment and
subsequent storage.
20


Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business