Data base content elements - std301320040020

DOE-STD-3013-2004

3) Quantity (mass) of material contents;

4) Conditions of material stabilization verification, including test results (if a qualified

process has been used for stabilization and packaging, then this entry shall be

the mean and standard deviation obtained during qualification testing and results

from the three most recent materials measurements for process control);

5) Source of stored material (e.g., site, facility and MBA that generated the material,

and IDC), if available;

6) Specific stabilization conditions to include date, temperature, processing duration

and equipment used and atmosphere (and a notation that a qualified process

was used, if applicable);

7) Particle density of the material and method by which determined, or reference to

a model that demonstrates such information is not needed to establish a

limitation on the mass loading; and

8) Other information relative to the contents such as expected major impurities with

source of impurity data (e.g., process knowledge, destructive analysis, or X-ray

fluorescence analysis).

2. The data base shall include, as a minimum, identification of the following package

characteristics:

1) Nominal fill gas composition of each container on sealing (e.g., air, helium, or

argon);

2) Leak test data record for the outer and inner containers in the package;

3) Package configuration - quantity and type of containers in a package;

4) Date of packaging for each container;

5) Initial radiation field [gamma and neutron at contact and 300 mm (12 in.)],

including how it was measured;

6) Baseline Package gross weight, dimensions, and tare weight;

7) The unique identification number and TID number, if any, associated with each

container; and

8) The manufacturer lot identification number for each container.