|
| DOE-HDBK-1092-98
work instructions involved, special precautions, energy source controls, and personal protective
equipment requirements.
If the work or operations to be performed during the work day are repetitive and similar, at least one
job briefing shall be conducted before the start of the first job of each day or shift. Additional job
briefings shall be held if significant changes, which might affect the safety of the employees, occur
during the course of the work.
A brief discussion is satisfactory if the work involved is routine and if the employee, by virtue of
training and experience, can reasonably be expected to recognize and avoid the hazards involved in
the job. A more extensive discussion shall be conducted if the work is complicated or extremely
hazardous, or the employee cannot be expected to recognize and avoid the hazards involved in the
job.
An employee working alone need not conduct a job briefing. However, the employee shall ensure
that the tasks to be performed are planned as if a briefing were required.
7.4 PERSONAL PROTECTIVE EQUIPMENT AND PROTECTIVE
CLOTHING
Employees shall wear appropriate personal protective equipment (PPE) and protective clothing (see
Section 7.4.8) to protect them from hazards of high-voltage apparatus. Employees authorized or
required to work on high-voltage systems shall be completely familiar with the PPE and protective
clothing they need for adequate protection while working on such systems. (Refer to Appendix C
for suggested types of PPE and protective clothing.) (See Figure 7-1 and Table 7-1.)
7.4.1 SHOES
Employees should wear shoes or boots that comply with the requirements of ANSI Z41. No metal
parts shall be present in the sole or heel of the shoes where nonconductive shoes are required.
7.4.2 SAFETY HAT
Workers should wear approved hardhats when working aboveground on poles, structures, or
buildings or in trees per ANSI Z89.1 and 29 CFR 1910.135.
Workers shall wear hardhats when working on the ground near poles, structures, buildings, or trees
in which work is being done. Workers shall wear hardhats when visiting or observing in areas where
overhead work is being done.
7.4.3 EYE PROTECTORS
Whenever eyes are in danger of being injured, workers shall wear safety goggles or other eye
protectors meeting ANSI standards. When the work being performed dictates, workers should wear
7-4
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |