Appendix B On-The-Job Training/Evaluation Guide cont'd

DOE-HDBK-1206-98

APPENDIX B

ON-THE-JOB TRAINING/EVALUATION GUIDE

ADMINISTRATIVE INFORMATION

TEST ID# 00000000000110-SP

REV.# 0

PAGE 1 OF 7

(1) TASK #:

TASK TITLE:

AVG. TIME TO PERFORM

00000000000110

REPLACING SPARK PLUGS

0.5 HOURS

(11)

PERFORMANCE EVALUATION

Action Step

Standards

A1.

Obtain

Trainee obtained the latest revised copies of

references.

the procedures

A2.

Remove the

All the remaining steps are in accordance with

boot

procedure #110A. Did not tug on the wire,

twisted gently off the plug.

A3.

Remove any

So that none will fall onto the hole.

S/C

dirt

A4.

Remove the

The correct socket is seated straight on the

S/C

plug

plug and turned counterclockwise.

A5.

Determine the

Plug determined to require replacement

S/C

condition of

the plug.

A6.

Gap the plug

Gap is correct for type of plug, either 0.025 -

S/C

0.027" or 0.033 - 0.035".

A7.

Install the plug

Tightened 1/4 turn beyond finger tight in the

S/C

clockwise direction.

A8.

Install the boot

Twisted gently onto the plug

S/C

A9.

Used

Procedure was out and referred to for each

Procedure

step

(12)

CODES

(S)

Sequence is important. This step must be performed only after preceding step(s)

(C)

Critical step. Failure to meet standard for this item constitutes failure of evaluation.

P & S refer to OJT performance evaluation levels of Perform and Simulate.

B-8