Preparing Reservoirs with a Stem that CANNOT be removed with Pliers

DOE-STD-1029-92

Appendix B

SOP-618-4

Revision 0

Approved October 22, 1991

Page 9 of 16

5.2

Preparing Reservoirs with a Stem that CANNOT be removed with Pliers

IF the reservoir has a wafer or stem that cannot be removed with pliers,

[1]

THEN perform the following steps:

(A lengthy series of steps has been omitted here. The omitted steps provide no

further exemplary guidance for producing a procedure)

PLUG WELDING

[1]

Ensure that these parts are available for use:

one 0.275 inch electrode

reservoir plug pieces (Part No. 14678), and

an appropriate weld fixture (identified in Section 3.2)

[2]

Start up welder.

[3]

IF welding plugs for the first time this week,

OR an electrodes has just been changed

OR a fixture has just been changed,

THEN GO TO SOP-618-23, performing a test weld

AND RETURN TO this procedure, Section 6, PLUG WELDING step [4]

[4]

Move the reservoir to the plug welding station.

[5]

Obtain a clean conical plug piece (Part No. 14678).

B - 10